Corn processing machinery mainly consists of elevators, dust removal equipment, air selection part, specific gravity selection part and vibration screening part. It has the characteristics of large processing capacity, small footprint, less labor required, and high productivity per kilowatt-hour. It is mainly used in the grain purchasing industry. Due to its high processing capacity and relatively low grain purity requirements, the compound selection machine is particularly suitable for users in the grain purchasing industry. After the materials are screened by the compound selection machine, they can be put into storage or packaged for sale. .
The structure of corn processing machinery is complex: Because it integrates the functions of the air screen cleaning machine and the specific gravity selection machine, its structure is relatively complex. Its installation and debugging require professional personnel to complete, otherwise it is likely to be due to installation and debugging. Unprofessionalism causes imbalances in the transmission components of the equipment, inaccurate air volume adjustment in various parts and other errors, thus affecting the clarity of the screening, the selection rate and the service life of the equipment.
The adjustment principles and maintenance methods of corn processing machinery are as follows:
Adjustment principles:
1. When the device is just started and running, it is recommended that the user adjust the handle to the uppermost position. At this time, the baffle is as shown in Figure 1. The materials are accumulated at the impurity discharge end of the specific gravity table to produce a certain material layer thickness.
2. The equipment runs for a period of time until the material covers the entire table and has a certain material layer thickness. At this time, gradually lower the handle position to gradually tilt the baffle. When the adjustment is made until there is no good material among the discharged impurities, it is the best baffle position.
Maintenance:
Before each operation, check whether the fastening screws of each part are loose, whether the rotation is flexible, whether there are any abnormal sounds, and whether the tension of the transmission belt is appropriate. Lubricate lubrication points.
If conditions are limited and you must work outdoors, you should find a sheltered place to park and place the machine downwind to reduce the impact of wind on the selection effect. When the wind speed is greater than level 3, the installation of wind barriers should be considered.
Cleaning and inspection should be carried out after each operation, and faults should be eliminated in time.
Post time: Oct-25-2023
