When the corn concentrator is working, the material enters the sieve body from the feed pipe, so that the material is evenly distributed along the width direction of the sieve. The large miscellaneous falls on the large miscellaneous sieve, and is discharged from the grain sorting machine on the big collection day, and the grain falls on the small miscellaneous sieve for full selection, and the sieve is small miscellaneous grains and barnyardgrass. The small miscellaneous is collected and discharged out of the machine, and the sieve is clean grain, which enters the stone removal sieve from the material guide pipe. Under the comprehensive effect of top-down vertical airflow and sieve body orientation and re-movement, automatic classification. The sand with a larger specific gravity sinks to the bottom and touches the sieve, and the grain particles with a smaller specific gravity and a rough surface float on the top and are in a suspended state. The lighter dust and rice husks are sucked away, and the grain grains on the upper layer slide down continuously under the effect of their own gravity and the directional movement effect of the sieve. When they flow out from the discharge day, only the sand and gravel attached to the sieve jump up to the inspection area. The grains mixed in the gravel are blown back to the separation area under the effect of the reverse air flow, while the gravel is discharged from the machine. The above is the working process of the small sorting machine.
Daily use and maintenance methods of corn selection machine:
1. Refuel the lubricating points before each operation.
2. Before operation, check whether the connecting screws of each part are fastened, whether the transmission parts rotate flexibly, whether there is any abnormal sound, and whether the tension of the transmission belt is appropriate.
3. Try to work indoors. The place where the machine should be parked should be flat and firm. The parking position should be convenient for dust removal.
4. If you need to change the variety during the operation, be sure to clean up the remaining seeds in the machine, and keep the machine running for 5 to 10 minutes.
The remaining species and impurities in the middle and back chambers.
5. If the conditions are limited and it is necessary to work outdoors, the machine should be parked in a sheltered place and placed along the wind to reduce the impact of wind on the selection effect.
6. Cleaning and inspection should be carried out after the end, and faults should be eliminated in time.
Post time: May-08-2023
