The seed coating machine is mainly composed of a material feeding mechanism, a material mixing mechanism, a cleaning mechanism, a mixing and conveying mechanism, a medicine supply mechanism and an electronic control system. The material mixing and conveying mechanism consists of a detachable auger shaft and a drive motor. It adopts Coupled design, the auger shaft is equipped with a shift fork and a rubber plate arranged at a certain angle. Its function is to further mix the material with the liquid and then discharge it out of the machine. The auger shaft is easy to disassemble, just loosen the end cover screw to remove it. Lower the auger shaft for cleaning.
1. Structural features:
1. Installed with a frequency converter, the machine has the following features during use: (1) The productivity can be adjusted easily; (2) The proportion of medicines can be adjusted at any productivity; once adjusted, the amount of medicine supplied can be adjusted according to the productivity. The changes will automatically increase or decrease so that the original proportion remains unchanged.
2. With the double slinging cup structure, the medicine is more fully atomized after two times in the atomizing device, so the coating pass rate is higher.
3. The drug supply pump has a simple structure, a large adjustment range for the drug supply, a stable drug amount, simple and convenient adjustment, no faults, and does not require maintenance by technical personnel.
4. The mixing shaft can be easily disassembled and cleaned, and is highly efficient. It adopts a combination of spiral propulsion and toothed plate mixing to achieve sufficient mixing and a high coating pass rate.
2. Operating procedures:
1. Before operation, carefully check whether the fasteners of each part of the machine are loose.
2. Clean the inside and outside of the icing machine pan.
3. Start the main motor and let the machine idle for 2 minutes to determine whether there is a fault.
4. After adding materials, you should first press the main motor button, then press the blower button according to the sugar crystallization situation, and turn on the electric heating wire switch at the same time.
The seed coating machine adopts frequency conversion control technology and is equipped with a variety of sensors and flow detection equipment, which reduces possible errors caused by human operation and improves the seed coating effect. There is no instability in the drug supply ratio of ordinary coating machines. And the problem of large changes in the rotation speed of the feeding system, the problem of seed coating film formation rate and uneven distribution; the liquid rejection plate has a wavy design, which can atomize the liquid evenly under high-speed rotation, making the atomized particles become Finer to improve coating uniformity.
In addition, there is a sensor on the spindle plate inspection door. When the access door is opened to inspect the spinner plate mechanism, the sensor will control the machine to stop running, which plays a role in safety protection. The material cleaning mechanism adopts a rubber scraper cleaning brush structure. During cleaning, Driven by the motor, the rotation of the nylon ring gear drives the cleaning brush to scrape off the material and chemical liquid adhered to the inner wall, and also stirs the material.
Post time: Jun-25-2024
